[an error occurred while processing this directive] [an error occurred while processing this directive] [an error occurred while processing this directive]
[an error occurred while processing this directive]

弹箭与制导学报 >

2021 , Vol. 41 >Issue 4: 15 - 19

DOI: https://doi.org/10.15892/j.cnki.djzdxb.2021.04.004

固体推进剂药柱点火瞬态裂纹尖端场研究

  • 龙兵 1 ,
  • 高双胜 1 ,
  • 金伟 2
展开
  • 1 常州工学院航空与机械工程学院,江苏常州 213032
  • 2 96811部队,浙江江山 324109

龙兵(1986—),男,安徽桐城人,讲师,博士,研究方向:固体火箭发动机失效物理与可靠性。

收稿日期: 2020-12-30

  网络出版日期: 2025-02-13

基金资助

江苏省高等学校自然科学研究面上项目(20KJB590001)

收起

Study on the Crack-tip Fields of Solid Propellant Grains at the Ignition Transient

  • LONG Bing 1 ,
  • GAO Shuangsheng 1 ,
  • JIN Wei 2
Expand
  • 1 School of Aviation and Mechanical Engineering, Changzhou Institute of Technology, Jiangsu Changzhou 213032, China
  • 2 No.96811 Unit, Zhejiang Jiangshan 324109, China

Received date: 2020-12-30

  Online published: 2025-02-13

Fold

摘要

采用线粘弹性模型,开展了药柱点火瞬态的动态裂纹尖端场仿真研究。结果表明,在裂尖及附近很小的区域内存在应力奇异性,且裂纹前端主要受拉应力的作用。裂尖应力应变随距裂尖距离r的增加而逐渐减小并趋于一定值;在θ处于0°~90°时,最大主应力和环向应变随θ的增大逐渐增大,而在θ处于90°~180°时则随着θ的增加而逐渐减小。在有限元计算结果的基础上得到了裂尖区域的张开型应力分布并计算了动态应力强度因子值,同文献中获得的推进剂动态断裂韧性结果进行比较,预测了裂纹的起裂危险性。

关键词： 药柱; 动态; 裂纹尖端场; 点火瞬态

本文引用格式

龙兵 , 高双胜 , 金伟 . 固体推进剂药柱点火瞬态裂纹尖端场研究[J]. 弹箭与制导学报, 2021 , 41(4) : 15 -19 . DOI: 10.15892/j.cnki.djzdxb.2021.04.004

Abstract

Based on the linear viscoelastic model, dynamic crack-tip fields of propellantgrains structure contains precrack under the ignition pressurization conditions is studied by numerical method. Stress singularity is existence at the crack tip and a very small area near the crack tip, and the front end of the crack is mainly subjected by tensile stress.The crack tip stress strain gradually decreases with the increase of the distance r and tends to a constant value. When θ is between 0° and 90°, the maximum principal stress and hoop strain increase with the angle increases, and when θ is between 90° and 180°, it gradually decreases as the angle increases.Based on the finite element calculation results, the open stress fields in crack-tip ahead are analyzed, and the dynamic stress intensity factors are obtained, and compared with the dynamic fracture experimental results, the fatalness of crack initiation is predicted.

Key words： propellant grain; dynamic; crack-tip fields; ignition transient

[an error occurred while processing this directive]

参考文献

原文顺序 | 文献年度倒序 | 文中引用次数倒序
[1]
CHYUAN S W. A study of loading history effect for thermovisclelastic solid propellant grains[J]. Computers & Structures, 2000, 77(6):735-745.

[2]
葛爱学. 固体火箭发动机点火过程与装药裂纹相互作用机理研究[D]. 长沙: 国防科学技术大学, 2004.

[3]
HO S Y, FONG C W. Correlation between fracture properties and dynamic mechanical relaxations in composite propellants[J]. Polymer, 1987, 28(5):739-744.

[4]
龙兵, 常新龙, 张有宏, 等. 高应变率下HTPB推进剂动态断裂性能研究[J]. 推进技术, 2015(3):471-475.

[5]
LONG B, CHANG X L, HU K, et al. Effects of temperature and strain rate on the dynamic fracture properties of HTPB propellant[J]. Propellants Explosives, Pyrotechnics, 2015, 40(4):479-483.

[6]
汪文强, 陈雄, 郑健, 等. 冲击载荷下CMDB推进剂断裂性能实验研究[J]. 固体火箭技术, 2015, 38(3):372-377.

[7]
赵汝岩, 王宏伟, 朱敏. 含典型装药裂纹模拟发动机点火瞬态试验研究[J]. 弹箭与制导学报, 2012, 32(2):131-132.

[8]
HAN B, JU Y T, ZHOU C S. Simulation of crack propagation in HTPB propellant using cohesive zone model[J]. Engineering Failure Analysis, 2012, 26:304-317.

[9]
李东. 固体推进剂药柱表面裂纹动态力学特性研究[D]. 南京: 南京理工大学, 2009.

[10]
钟涛, 张为华, 王中伟. 点火瞬态过程对复合固体推进剂力学响应特性的影响[J]. 国防科技大学学报, 2004, 26(3):7-10.

[11]
HO S Y. High strain-rate constitutive models for solidrocket propellants[J]. Journal of Propulsion and Power, 2002, 18(5):1106-1111.

[12]
WILLIAMS M L. On the stress distribution at the base of a stationary crack[J]. Appl Mech, 1957, 24:109-114.

[13]
KIM Y, CHAO Y J. Effect of loading rate on dynamic fracture initiation toughness of brittle materials[J]. International Journal of Fracture, 2007, 145:195-204.

Options
文章导航

/

〈 〉

[an error occurred while processing this directive]