[an error occurred while processing this directive] [an error occurred while processing this directive] [an error occurred while processing this directive]
[an error occurred while processing this directive]

弹箭与制导学报 >

2011 , Vol. 31 >Issue 2: 86 - 88

DOI: https://doi.org/10.15892/j.cnki.djzdxb.2011.02.060

弹药技术

不同装药工艺对装药安定性的影响

  • 张涛 ,
  • 肖洋 ,
  • 郭晓红 ,
  • 李鹏飞 ,
  • 姚兴柱
展开
  • 中国兵器工业第204研究所,西安 710065

张涛(1977-),男,河南商丘人,工程师,研究方向:战斗部研制。

收稿日期: 2010-01-18

  网络出版日期: 2025-05-30

收起

The Effect of Different Charging Process on Charge Safety

  • ZHANG Tao ,
  • XIAO Yang ,
  • GUO Xiaohong ,
  • LI Pengfei ,
  • YAO Xingzhu
Expand
  • No. 204 Research Institute of China Ordnane Industries, Xi'an 710065, China

Received date: 2010-01-18

  Online published: 2025-05-30

Fold

摘要

利用大落锤撞击模拟加载装置,对注装、压装、浇注三种装药条件下的不同炸药进行了加载应力试验,并对三种装药工艺进行了地面动态装药安定性打靶试验,试验结果表明,在装药其它条件相同的情况下,压装药相对钝感,其安定性优于注装药及浇注药

关键词： 模拟加载; 装药安定性; 加载应力试验; 装药工艺

本文引用格式

张涛 , 肖洋 , 郭晓红 , 李鹏飞 , 姚兴柱 . 不同装药工艺对装药安定性的影响[J]. 弹箭与制导学报, 2011 , 31(2) : 86 -88 . DOI: 10.15892/j.cnki.djzdxb.2011.02.060

Abstract

The stress tests of cast-loaded charge, press-loading charge and casting charge were performed by the big dropping hammer shocking on the simulated load device respectively, and their ground dynamic safety tests were completed by shocking at hard target on test range. The results showed the sensitivity of press-loading charge was lower than cast-loaded charge and casting charges under the same test condition.

Key words： simulated load; charge safety; load stress test; charge process

[an error occurred while processing this directive]

参考文献

[1]
黄正平. 炸药装药发射安全性研究的文献调研报告[R]. 北京: 北京理工大学.
[2]
王儒策, 赵国志. 弹道终点效应[M]. 北京: 北京理工大学出版社, 1993.
[3]
都兴良. 国内外炮弹膛炸事故及分析[M]. 南京: 南京理工大学出版社, 1995.
[4]
王淑萍. 撞击作用下炸药装药的尺寸效应研究[J]. 火炸药学报, 2000, 23(4): 18-20.
Options
文章导航

/

〈 〉

[an error occurred while processing this directive]