[an error occurred while processing this directive] [an error occurred while processing this directive]
[an error occurred while processing this directive]固体火箭发动机摆动喷管两相流场与性能分析
|
童悦(1988-),男,江西黎川人,工程师,硕士,研究方向:固体发动机结构设计与仿真研究。 |
收稿日期: 2019-03-27
网络出版日期: 2025-05-30
Two-phase Flow and Performance Characteristics in a Gimbaled Nozzle of Solid Rocket Motor
Received date: 2019-03-27
Online published: 2025-05-30
童悦 , 郑庆 , 李修明 , 陈俊 , 林啸 . 固体火箭发动机摆动喷管两相流场与性能分析[J]. 弹箭与制导学报, 2020 , 40(2) : 79 -82 . DOI: 10.15892/j.cnki.djzdxb.2020.02.020
In order to study the gimbaled nozzle’s performance characteristics under the gas, producing by solid rocket motor (SRM).The Discrete Phase Model was used to numerically investigate the complicated muli-phase flow fields in the gimbaled nozzle.The influence of condensed particle’s size and concentration were discussed, when the nozzle without swing or swinging 5 degrees.Results indicate that, no matter the nozzle swings or not, with the increase of the particle’s size and concentration, the nozzle efficiency decrease obviously, but the thrust coefficient increase as the concentration of particle increasing.When the nozzle without swing, the thrust coefficient wouldn’t change with the size of the condensed particle, however, it will decrease with the enlarging size of particle, when the nozzle swings 5 degrees.Moreover, the trajectories of the small particles vary little with the swinging nozzle’s gas flow, amplifying the vector angle, while the big particles obeys an inverse law.
Key words: gimbaled nozzle; two-phase flow; thrust coefficient; nozzle efficiency
| [1] |
|
| [2] |
|
| [3] |
何国强, 王国辉, 蔡体敏, 等. 过载条件下固体发动机内流场数值模拟[J]. 推进技术, 2002, 23(3):182-185.
|
| [4] |
李越森, 叶定友. 高过载下固体发动机内Al2O3粒子运动状况的数值模拟[J]. 固体火箭技术, 2008, 31(1):24-27.
|
| [5] |
刘长猛, 语贞男, 李侃. 飞行过载下燃烧室凝相粒子沉积特征数值研究[J]. 固体火箭技术, 2017, 40(3):302-306.
|
| [6] |
刘中兵, 郜伟伟. 固体发动机飞行横向过载下绝热层烧蚀探究[J]. 固体火箭技术, 2018, 41(4):435-440.
|
| [7] |
张旭. 固体火箭发动机两相流特性研究[D]. 哈尔滨: 哈尔滨工程大学, 2006.
|
| [8] |
杨丹. 固体火箭发动机气-固两相流的数值模拟[D]. 哈尔滨: 哈尔滨工程大学, 2006.
|
| [9] |
武利敏. 固体火箭发动机两相流计算模型分析与比较[D]. 哈尔滨: 哈尔滨工程大学, 2007.
|
| [10] |
任军学, 刘宇, 谢侃. 固体火箭发动机塞式喷管两相流场与性能分析[J]. 航空学报, 2007, 28(增刊):23-27.
|
| [11] |
谢侃, 刘宇, 任军学, 等. 两相流环缝塞式喷管理想型面的设计方法[J]. 固体火箭技术, 2007, 30(3):223-228.
|
| [12] |
谢侃, 刘宇, 任军学, 等. 两相流环缝塞式喷管设计方法[J]. 航空学报, 2007, 28(6):1339-1344.
|
| [13] |
张宏安, 叶定友, 侯晓. 固体火箭发动机凝聚相微粒分布研究现状[J]. 固体火箭技术, 2000, 23(3):25-28.
|
| [14] |
张宏安, 叶定友, 侯晓, 等. 固体发动机喷管出口凝相微粒粒度分布研究[J]. 固体火箭技术, 2001, 24(3):14-18.
|
| [15] |
彭小波, 张胜敏, 万小朋. 高温高压环境中凝相颗粒粒度分布实验研究[J]. 弹箭与制导学报, 2012, 32(3):141-144.
|
| [16] |
|
| [17] |
|
/
| 〈 |
|
〉 |