[an error occurred while processing this directive] [an error occurred while processing this directive] [an error occurred while processing this directive]
[an error occurred while processing this directive]

Journal of Projectiles, Rockets, Missiles and Guidance >

2013 , Vol. 33 >Issue 1: 19 - 24

DOI: https://doi.org/10.15892/j.cnki.djzdxb.2013.01.002

MISSILES AND GUIDANCE TECHNOLOGY

The Influence of Turntable Fixing Errors on Optical Gyro Strapdown Inertial System Calibration

  • DING Feng ,
  • FENG Lishuang ,
  • CHAO Daihong ,
  • SONG Lailiang
Expand
  • School of Instrument Science and Opto-electronics Engineering, Beijing University of Aeronautics and Astronautics, Beijing 100191, China

Received date: 2012-05-18

  Online published: 2025-05-24

Fold

Abstract

The mathematic relations between fixing error of two-axis turntable and the calibration parameters were derived for analyzing the influence of the fixing errors of turntable on the optical gyro strapdown inertial system calibration. The influence of the horizontal and the orientational fixing errors of turntable on the calibration parameters were analyzed quantificationally. The conclusions are drawn as follows: fixing errors of turntable have no influence on the calibration parameters of three gyros and the biases of three accelerometers. The scale factor errors of three accelerometers are 10-5 when the horizontal error is 11´. Assuming real misalignment angles of three accelerometers are 5 and the horizontal error of turntable is 1º, the calibration errors of misalignment angles are only 0.1". The results can be applied to adjusting the two-axis turntable.

Key words： fixing errors; two-axis turntable; schism calibration; error analysis

Cite this article

DING Feng , FENG Lishuang , CHAO Daihong , SONG Lailiang . The Influence of Turntable Fixing Errors on Optical Gyro Strapdown Inertial System Calibration[J]. Journal of Projectiles, Rockets, Missiles and Guidance, 2013 , 33(1) : 19 -24 . DOI: 10.15892/j.cnki.djzdxb.2013.01.002

[an error occurred while processing this directive]

References

[1]
Dongkyu Lee，Sangchul Lee，et al． Test and error parameter estimation for MEMS based low cost IMU calibration[J]. International Journal of Precision Engineering and Manufacturing，2011，12(4): 597 - 603．
[2]
肖龙旭，魏诗卉，孙文胜．惯测组合快速高精度标定方法研究[J]. 宇航学报，2008，29(1): 172 - 177．
[3]
严恭敏，秦永远．激光捷联惯组的双轴位置转台标定仿真[J]. 中国惯性技术学报，2007，15(1): 123 - 127．
[4]
张红良. 惯性测量组合零偏的一种现场标定方法[J]. 弹箭与制导学报, 2009, 29(4): 4- 7.
[5]
肖桂平. 光学陀螺捷联惯导系统的标定精度分析[D]. 长沙: 国防科技大学, 2008.
Options
Outlines

/

〈 〉

[an error occurred while processing this directive]