[an error occurred while processing this directive] [an error occurred while processing this directive]
[an error occurred while processing this directive]Journal of Projectiles, Rockets, Missiles and Guidance >
Study on Penetration Law of Ogive-nose Projectile in a Wide Velocity Range
Received date: 2024-06-04
Online published: 2024-12-18
In order to study the penetration power of ogive-nose projectile under the condition of wide velocity range, the ANSYS/LS-DYNA finite element analysis software is used to simulate the penetration of the ogive-nose projectile into concrete target plate without considering the impact response characteristics of its range. The effects of projectile material, caliber radius head, length-diameter ratio and mass on the penetration performance are studied under the impact velocity of 2.0Ma~6.0Ma. The results show that with the increase of the target velocity, the dimensionless penetration depth of the projectile increases first and then decreases. At the same time, compared with 93 tungsten alloy and TA7 titanium alloy, the penetration performance of G50 alloy steel is better. The caliber radius head has a significant effect on the dimensionless penetration depth during low-speed penetration, and the degree of influence is reduced during ultra-high-speed penetrating. The optimal caliber radius head ratio of the projectile is 3~4. The length-diameter ratio is positively correlated with the penetration depth at low speed penetration and negatively correlated with the penetration depth at ultra-high speed penetrating. The dimensionless penetration depth decreases with the increase of the length-diameter ratio, and the optimal length-diameter ratio of the projectile is 4~5. The mass has a significant effect on the depth of penetration, and has little effect on the dimensionless depth of penetration and the critical transformation rate. The critical transformation rate appears at 3.5Ma~4Ma.
Key words: ogive-nose projectile; wide velocity range; concrete; numerical simulation
HOU Xuhua , YIN Likui , QU Qiankun , LIANG Jiadong , LAN Yupeng , WANG Junfeng , YANG Rui , CHEN Zhigang . Study on Penetration Law of Ogive-nose Projectile in a Wide Velocity Range[J]. Journal of Projectiles, Rockets, Missiles and Guidance, 2024 , 44(4) : 62 -71 . DOI: 10.15892/j.cnki.djzdxb.2024.04.008
| [1] |
|
| [2] |
|
| [3] |
何翔, 徐翔云, 孙桂娟, 等. 弹体高速侵彻混凝土的效应实验[J]. 爆炸与冲击, 2010, 30(1): 1-6.
|
| [4] |
王可慧, 宁建国, 李志康, 等. 高速弹体非正侵彻混凝土靶的弹道偏转实验研究[J]. 高压物理学报, 2013, 27(4): 561-566.
|
| [5] |
|
| [6] |
|
| [7] |
|
| [8] |
|
| [9] |
|
| [10] |
宋梅利, 李文彬, 王晓鸣, 等. 弹体高速侵彻效率的实验和量纲分析[J]. 爆炸与冲击, 2016, 36(6): 752-758.
|
| [11] |
姚志彦, 李金柱, 齐凯丽, 等. 长杆弹超高速侵彻砂浆靶临界速度的实验和计算[J]. 兵工学报, 2022, 43(7): 1578-1588.
|
| [12] |
|
| [13] |
高飞, 张国凯, 纪玉国, 等. 卵形弹体超高速侵彻砂浆靶的响应特性[J]. 兵工学报, 2020, 41(10): 1979-1987.
|
| [14] |
|
| [15] |
钱伟长. 穿甲力学[M]. 北京: 国防工业出版社, 1984: 29-32.
|
| [16] |
徐英, 时家明, 林志丹. 弹丸头部形状和长径比对侵彻过程的影响研究[J]. 弹箭与制导学报, 2009, 29(5): 135-138.
|
| [17] |
陈小伟. 动能深侵彻弹的力学设计: 侵彻/穿甲理论和弹壁厚分析[J]. 爆炸与冲击, 2005, 25(6): 135-138.
|
| [18] |
陈小伟, 张方举, 杨世全. 动能深侵彻弹的力学设计: 缩比实验分析[J]. 爆炸与冲击, 2006, 26(2): 105-114.
|
| [19] |
夏靖雯, 陈智刚, 顾敏辉, 等. 钨合金破片侵彻2024铝靶的数值模拟研究[J]. 振动与冲击, 2023, 42(15): 156-162.
|
| [20] |
孔庆强, 沈飞, 邢逸凡, 等. G50钢与G31钢动态力学性能的对比试验研究[J]. 高压物理学报, 2021, 35(1): 70-76.
|
| [21] |
王艳玲. 钛合金动态力学性能与抗弹性能关系研究[D]. 北京: 北京有色金属研究总院, 2016.
|
| [22] |
李洪超. 岩石RHT模型理论及主要参数确定方法研究[D]. 北京: 中国矿业大学, 2017.
|
| [23] |
牛振坤, 陈小伟, 邓勇军, 等. 混凝土靶侵彻过程中空腔膨胀响应分区[J]. 爆炸与冲击, 2019, 39(2): 50-58.
|
/
| 〈 |
|
〉 |